35156AA
12
Weather Resistant Cable Connector
This camera features an IP66-rated weather resistant connector. For
unprotected outdoor connections, screw the connector on the included
Ethernet camera cable onto the camera dongle. If your installation
location does not require a water resistant connection, loosen and slide
the connector back on the cable until it’s out of the way.
This camera features an IP66-rated waterproof cable connector for
unprotected outdoor connections.
You do not need to re-terminate
the cable to use the waterproof cable connector.
Included Pieces:
Thread Lock Cap
Silicone Seal Ring
RJ45 Enclosure
Small Silicone “O”
Ring
To Install the weather resistant cable connector, follow these steps:
1. Slide all pieces of the waterproof cable connector over the cable
plug in this order:
•
Thread Lock Cap
•
Flexible silicone seal ring. You will need to stretch the silicone
seal over the RJ-45 plug.
TIP
:
Insert the flexible silicone seal ring onto the tip of a pair of
needle nose pliers and stretch the seal over the RJ45 plug
•
RJ45 Enclosure
2. Stretch the small silicone “O” ring onto the camera dongle
3. Connect the camera cable to the plug on the dongle. Screw the
RJ45 Enclosure into the dongle.
4. Insert the flexible silicone seal into the “crown” section of the large
plastic ring
5. Screw the small plastic ring into the large plastic ring
TIP:
To remove the RJ45 enclosure from the plug, tape down
the locking tab with electrical or office tape.
CAUTION:
Do not attempt to disconnect the camera connection
without loosening the smaller thread lock cap. Do not force.
Forcing the assembly will break the camera dongle and will
void camera warranty.
