AVerMedia AVerKey550 User’s Manual
30
When the signal runs through a VCR, there is no picture on the TV.
1. Check your TV/VCR input channel setting.
2. If your TV and VCR are connected to an AV Amplifier, please check the
input/output selection.
I have set up
AVerKey
550
and checked all the connections as specified in the
manual, but I can only get a picture on the VGA monitor, not on the TV screen.
AVerKey
550
is in "Ready" mode once power is connected. You need to
switch
AVerKey
550
"ON", either
from the Remote Control or Touch-Button
Panel Control to display both VGA and VIDEO.
The picture on my TV is all messed up.
When using
AVerKey
550
with IBM PC compatible computers, only screen
resolutions up to 1600 x 1200 (horizontal frequency less than 108KHz) are
supported.
While using the remote control or wired mouse, the PC does not respond. (The
mouse cursor does not appear on-screen; the mouse cursor won't move.)
1. Make sure that power is connected. Check and see if the
READY
LED on the
AVerKey
550
front panel is on.
2. Check if the RS-232 cable is securely connected to the
AVerKey
550
"
PC/ADB
" port.
3. Make sure that the mouse driver has been invoked successfully.
4. If you are using a wired mouse,
AVerKey
550
can support the standard
(two-button) MS mouse.
5. If you're using the remote control unit, make sure that the batteries have
enough power.
