Avermedia AVerAI EN713, Manual

Page: 26 / 27

26
6.0 Force Recovery Mode
USB 3.l/OTG port (J11) can be used to re-program
NVIDIA
®
Jetson Nano/ Xavier NX module by using the
other
host system running NVIDIA Jetpack
TM
, as the procedure described below.
1.
Power off the system. Ensure the system power must be completely OFF, instead of staying in
the suspend mode or the sleep mode.
2.
Connect a USB cable from OTG USB port to the other host system which will be used to re-program
the new system file into
NVIDIA
®
Jetson Nano/ Xavier NX module
.
3.
Press and hold down Force Recovery Butto n (SW8) and then power on the carrier board.
4.
After three seconds, release Force Recovery Button.
5. NVIDIA
®
Jetson Nano/ Xavier NX module
will show up on the USB list of the host system as a new
NVIDIA target device.
6.
After the system software is updated successfully, please ensure to power off the system. A clean
power-on will then revert OTG port back to the host mode.