www.avenview.com
Page 5
CW-HDMDVI-100 Scaler/Converter (continued)
Connect a source output to the W-hDM3D-S-100 (transmitter) using a DVI to hDMI cable. For non-standard source signals,
use the CW-hDMDVI-100 scaler/converter between the source and the Tx.
Step 3
: Connect the Receiver Unit (Rx) to a Destination
After the complete system,
including Rx and display
monitor, is connected, press
here to cycle though the
output modes generated by
W-hDM3D-S-100
use the patch cables
(included) to bring power
and the hDMI signal from
W-hDM3D-S-100 to the
wireless Tx unit.
Connect a source’s output
to the DVI in port on
W-hDM3D-S-100
Connect the power cord into an available electrical outlet,
and to the DC in port on W-hDM3D-S-100 . As with the Rx
and Tx units, the DC Splitter accessory can be used to obtain
power from an FSN medical display monitor.
Connect the W-hDM3D-S-100 Rx
(receiver) to a destination using an
hDMI to DVI cable.
Pressing the mode button, and waiting approx. 8 seconds, will
temporarily display the following dialog on the monitor:
Input signal type.
Converted output signal type. Pressing the mode button again
will move to the next output type, and loop through all modes.
