Programming
•
Assigning keypad to the control unit
. After supplying power to the keypad the buzzer beeps and all
LEDs blink: (connect and) disconnect the control unit within 60 seconds. Upon disconnection the control
unit is linked to the keypad, confirmed by 6 beeps of the buzzer and by the LEDs going off.
•
Programming and deletion of 5 figure codes for connecting and disconnecting the control unit:
the operation is performed on the control unit as indicated in the respective manual.
•
Programming Panic and Tamper alarms
: set the control unit in programming on zone
24H PANIC or
24H ROBBERY
according to the required alarm. Hold the panic button (!) pressed for 10 seconds: the
control unit confirms (beep) successful programming. Also the tamper alarm of the keypad is
programmed in this manner. Opening the keypad or removing it from the wall triggers the control unit
alarm.
•
Programming button F2
: set the control unit in programming on zone
24H PANIC or 24H ROBBERY
according to the required alarm and press the button for 10 seconds. The control unit confirms (beep)
successful programming
Using the keypad to control radio receivers
The AF979R-DB keypad dialogues via radio with the R1R receivers for controlling general loads, sending step
by step commands through button F1 or monostable (timed) commands through button F2. Furthermore, it
dialogues with RT1R receivers to control roller shutter motors, sending timed commands. The keypad may
serve both purposes (burglar alarm and controlling receivers) in the same system due to a simple choice of
code:
•
The five figure code (100.000 combinations) is intended for burglar alarm applications.
•
A code with up to 4 figures allows to control up to 10.000 receivers
It is thus possible to associate to the load to be commanded, and hence the respective receiver, an easily
memorisable number of codes. Example, using the R1R receiver: entrance light
1
, external lights
20
, staircase
lights
600
, etc.
After suitably memorising the codes of the keypad in the memory of the receiver, the keypad shall operate as
follows:
•
Receiver code (max 4 figures) + Red button: receiver output ON
•
Receiver code (max 4 figures) + Green button: receiver output OFF
For all details regarding this application, see the receivers manual.
