7
TO FIT 6.4 mm (1/4”) BORE PIPE
L = 137 cm
1/4” BSP
HOSE CONNECTOR
part nº 07005-00276
HOSE ASSSEMBLY
part nº 07008-00324
1/4” BSP
1/4” BSP
SWIVEL CONNECTOR
part nº 07640-01400
A C C E S S O R I E S
Three different accessories are available to make the connection to your air supply:
FOR 07611 MODEL
part nº 07611-00400
FOR 07613/4 MODELS
part nº 07498-03700
I M P O R T A N T
The stem collector MUST be emptied frequently, approximately when half full or every 120 placings.
OPTION 2
■
Ensure that the correct nose equipment is fitted.
■
Connect the tool to the air supply.
■
Insert the fastener stem into the nose of the tool.
■
Insert the tool with the fastener squarely into the prepared hole of the
application.
■
Fully operate the trigger. The tool cycle will ensure the fastener is
placed.
Approximate dimensions of assembled unit are:
Length: 107mm (4.2”)
Diameter: 63.5mm (2.5”)
ADAPTOR
(ON 07611 MODEL)
LOCKING RING
CLAMP WASHER
STEM COLLECTOR
To better control waste, a stem collector
can be fitted as an alternative to the stand-
ard stem deflector.
■
To fit the stem collector, unscrew the end
cap and remove together with the stem
deflector (items 9 and 10 of page 14 to 17).
■
Assemble the stem collector as shown on
the drawing opposite.
■
Push the assembly onto the cylinder end
plug (item 11 of page 14 to 17).
■
Secure by finger tightening the previously
removed adaptor on the 07611 model or
the locking ring supplied for the 07613
and 07614 models over the clamp
washer.
■
Rotate the stem collector body until the
opening is in the desired position.
■
Fully tighten the adaptor or locking ring.
07614 model for HEMLOK
When placing Hemlok, two different approaches may be used, both
resulting in equal quality placing. OPTION 1 brings the tool to the
fastener already positioned in the application hole while OPTION 2
positions the fastener in the tool, or specifically in its nose assembly,
then brings them together to the application.
Use which ever suits your environment and application.
OPTION 1
■
Ensure that the correct nose equipment is fitted.
■
Connect the tool to the air supply.
■
Insert the fastener body squarely into the prepared hole of the
application as shown right.
■
Apply the tool to the protruding fastener stem.
■
Fully operate the trigger. The tool cycle will ensure the fastener is
placed.
Summary of Contents for 7611
Page 22: ......
