5
Configure the Module
L
Before you can set up the X330W-2USP module you must power on and set up the
Avaya P330 stack as described in the Avaya P330 User’s Guide.
L
You can configure the X330W-2USP module either via its console port or by opening a
session to the module from the P330 switch in which the module is installed using the
session wan
command.
Avaya CLI Hints and Tips
CLI Command Conventions
•
CLI commands for you to enter are in the
computer bold
font.
•
Information displayed on screen as well as parameters of a command are displayed in
computer
font.
•
Parameters that you enter are in pointed brackets <>.
•
Alternative but mandatory keywords are grouped in braces {} and separated by a vertical bar
|.
•
Optional keywords are in square brackets [ ] and options are separated by a vertical bar |.
•
If you enter an alphanumeric string of two words or more, enclose the string in quotes.
The Avaya CLI has several features which improve ease of use:
•
To display all commands available in a context type a question mark.
•
To display all commands starting with a certain string, type the first few letters followed by a
question mark.
•
To get help containing all commands parameters with their legal values as well as its syntax
and an example, type a question mark at the end of command or at the stage where it is
unique.
•
Use the Tab key to complete an unambiguous command.
The following steps describe how to configure the X330W-2USP module using the Avaya CLI.
Establishing a Console (Serial) Connection
Perform the following steps to connect a terminal to the Console port of the X330W-2USP for
configuration of WAN parameters using the CLI:
1
Use the supplied serial cable to attach the RJ-45 console connector to the Console port.
Connect the DB-9 connector to the serial (COM) port on your PC/terminal.
2
Use the following serial port settings on the PC: 9600 baud, 8 bits, 1 stop bit and no parity. If
you connected a PC, run a VT-100 emulation session. (You can use the Windows®
HyperTerminal.)
L
The terminal connected to the serial port must be configured with the same settings; this
setting will work with any PC COM port over a DB9 to RJ45 connector.
3
Press the Enter key.