Caution:
Risk of high current and board burn out if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Warning:
The lithium battery is not field replaceable. It must only be removed and replaced by authorized
personnel. Contact Avaya Technical Support for assistance if the battery requires replacement.
Before you begin
Ensure the area where you install and use the VSP 4000 switch meets the following environmental
requirements:
• Ambient temperature between 32° and 122° F (0° and 50° C)
• Relative humidity between 0% and 95% noncondensing
• No nearby heat sources such as hot air vents or direct sunlight
• No nearby sources of severe electromagnetic noise
• No excessive dust
• Adequate power source within six feet; one 15-Amp circuit required for each power supply
• At least 2 inches (5.08 cm) on all sides of the switch unit for ventilation
• Adequate space at the front and rear of the switch for access to cables
If you are installing a single VSP 4000 switch on a table or shelf, ensure the surface can support at
least 15 to 20 pounds (7 to 9 kilograms).
Installing the Avaya VSP 4450GSX series switches
The VSP 4450GSX series consists of the 4450GSX-PWR+, 4450GSX-DC and the TAA compliant
versions.
Warning:
Do not use the ERS to VSP conversion kit (part number EC4810003-3.0) with these chassis .
The kit is incompatible with the VSP 4450GSX series switches.
Note:
A factory-supplied 4450GSX series switch has a USB slot but no USB device or cover.
Installing the Avaya VSP 4000 switch on a table or shelf
You can install a single Avaya VSP 4000 switch on any flat surface. The surface must support the
combined weight of the switch and attached cables (from 15 and 20 pounds [7 to 9 kilograms]).
July 2015
Installation Job Aid for Avaya VSP 4000 4450GSX series
3