Avaya P334T, User Manual, Page: 128 / 182

Chapter 6 CLI – Layer 2
112 Avaya P334T User’s Guide
The syntax for this command is:
set inband vlan <value>
Output Example:
P330-N# set inband vlan 1
Management VLAN number set to 1
set vlan
Use the
set vlan
command to create VLANs.
The syntax for this command is:
set vlan <vlan-id> [name <vlan-name>]
Output Example:
P330-N# set vlan 3 name v3
VLAN ID 3 is named v3.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
set port flowcontrol
Use the
set port flowcontrol
command to set the send/receive mode for
flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each
direction (send or receive) can be configured separately only for Gigabit Ethernet
ports. Proprietary flow control cannot be configured on Gigabit ports. The
set
flowcontrol
command cannot be used on Gigabit ports for which
autonegotiation is enabled.
The syntax for this command is:
set flowcontrol [direction] [module/port] [value]
where the parameters of
direction
are
receive|send|all
, and the parameters
of
value
are
on|off|proprietary
.
value A VLAN number between 1 and 3071.
vlan-id vlan number
vlan-name vlan name