NEC 2400
Confidential
The information contained in this document is provided by AVAYA Inc. to serve as a guide. See the disclaimer on page 1
4
The settings for SW01 should be as follows: Settings 1, 2, and 3 set to
off
,
on
,
off
for a baud rate of 9600 BPS. Setting 4 is set to on for
Parity Bit valid. Setting 5 is set to
on
for odd parity. Setting 6 is set to
on
for 7 bits. Setting 7 is set to
off
for 2 stop bits. Setting 8 is set to
on
for Send Side FIFO is 1 byte. See
Figure 2
.
1
2
3
4
5
6
7
8
SW01
off
on
off
on
on
on
off
on
Figure 2.
NOTE:
If using Port 2 on the I/O-02 card, configure the settings on SW11
the same as above.
The settings for SW02 or SW12 should be as follows: Setting 1 is set
to
on
for PB signal not provided. Setting 2 is set to
on
for DTR.
Setting 3 is set to
off
for DSR is provided. Setting 4 is set to
off
for
CD is provided. Settings 5, 6, and 7 are set to
on
for CS, CI, and PB
not provided. Setting 8 is not used. See Figure 3.
1
2
3
4
5
6
7
8
SW02
on
on
off
off
on
on
on
off
Figure 3.
NOTE:
If using Port 2 on the I/O-02 card, configure the settings on SW12
the same as above
.
o
Verify that all four settings on SW13 are
off
. The card is now
configured for RS-232 operation.
NOTE:
If the PBX is taken out of service and restarted, the MCI port
might not operate. If this is the case, unplug the RS-232 link from the
Octel voice module, then have the PBX vendor reset the system
processor.
5.1 CONFIGURING THE VOICE LINES
o
Assign single-line ports for the Octel system in the ASDT (Assign
Station Data Table) with TEC=3.
o
Assign a Service Feature Class (SFC) to those ports. Within the
SFC, disable the Distinctive Ringing feature for all ports. This is
accomplished with ASFC Index 48. If this feature is enabled,
problems with integration occur.
o
Assign the Octel voice ports to a UCD group using the ASHU
command.
The pilot number of the above UCD group is the
Octel voice module
Access
Number
. It is used by subscribers to call the Octel voice
module to retrieve their messages. It is also used by subscribers to
forward their phones to the Octel voice module.
Configuring the single-line ports
for the Octel System