Page 14 - Installation
Installing the CSLC Cassette
Installation
Installing the CSLC Cassette
This section covers installation of a CSLC cassette
– Only 1 of the following cassette types (that covers ALOG, BRIC, COMBO
and CLSC cassettes) should be used in a cabinet with a PSU4
– A maximum of 80 simultaneous ringing analogue extensions is supported
per cabinet (112 extensions if using an ALOG 0/24 cassette)
– Cabinets fully equipped with ALOG cassettes are not recommended for high
traffic environments such as call centres
To install a CSLC cassette :
1. Ensure that you have the correct cassette. The cassette label shows its type as
"CSLC8 "
or
"CSLC16 ".
2. Remove the screw at the top of the slot to be used. Insert the new cassette
3. After insertion of the cassette, there will be a delay, the length of which is
dependant upon the number of base stations, before the lamp status stabilizes.
Check which lamps come on.
–
Green On/Red Off :
Power supply to cassette okay
–
Green Off :
Swap cassette, if the problem persists, check the PSU/CPU
–
Red On :
Swap cassette, if the problem persists, check the PSU/CPU
–
Red flashing :
Check that the selected slot is not 'locked out'
(Administration/Linecard Information/Linecard)
4. Secure the cassette using its top tab
(using the screw previously removed)
5. Connect the INDeX 32-pair cable to the cassette. Attach the cable's P-clip to the
appropriate point at the base of the cabinet for the cassette slot
6. Cable tie the cable to the base of the cassette.
Page 14
Installation Manual
38DHB0002UKCA – Issue 8 (26/03/2002)
INDeX CSLC