Setting Up a Divert
Diverting Calls – Page 15
Setting Up a Divert
Before
Divert
can be switched on, you must set-up the type of
divert
you require
and the number you wish to divert to.
When divert all is on, you hear broken dial tone when you lift the handset. You
can still make calls. Switching
Divert all
on takes the phone out of group.
To set-up a divert number:
1. Lift the handset and immediately dial
0
. You will hear:
2.
Broken dial tone:
Select required divert by:
Dialling
10
(divert all)
,
Dialling
11
(divert on busy)
or
Dialling
12
(divert on no answer)
. You will hear:
3.
Loud pip:
Dial your passcode
(see page 16)
.
You will then hear either:-
•
Continuous tone:
Passcode wrong, replace the handset.
•
Three soft-tones:
Divert number already set.
To clear the stored number, press .
•
Single soft tone:
No divert number set.
4. To set a divert number, press
and then dial the number
followed by
#
. If
you enter an external number (max. of 28 digits) remember to add the
normal external call prefix. You will hear either:
•
Continuous tone:
Invalid number.
Replace the handset and start again.
•
Broken dial tone:
Number entered accepted and Divert
is switched on. Replace the handset.
Switching a Divert On or Off
When divert all is on, you hear broken dial tone when you lift the handset. You
can still make calls. Switching
Divert all
on takes the phone out of group.
To switch divert ON:
1. Lift the handset and immediately dial
0
. You will hear the dial tone.
To switch Divert OFF:
1. Lift the handset and immediately dial
7
. You will hear the normal dial
tone.
INDeX 10.1 4602 IP Telephone User's Guide
Diverting Calls – Page 15
38DHB0002UKFV Issue 1 (28/05/2003)
Setting Up a Divert
