Installation
Issue 5 August 2005
19
Labeling and Installing the Button-Designation
Cards and Covers
4
NOTE:
The cards and covers are shipped as loose items with the CALLMASTER IV
voice terminal.
1. Make sure that the voice terminal is right side up.
2. Type or write the numbers/features on the button designation cards with the
appropriate button information.See
Figure 5
.
3. Crease the perforated edges of the button designation cards and then
remove the cards.
4. If the clear plastic card cover has already been installed on the voice
terminal, remove the cover on the right side of the CALLMASTER IV by
gently lifting the plastic cover, with your fingernail, at the slot on the right of
the set (for the card on the right).
5. If the plastic card cover has not been previously installed on your
CALLMASTER IV, go on to the next step.
NOTE:
If you need to remove the clear card cover on the left side of the set, gently
lift the plastic cover, with your fingernail, at the slot on the left of the set.
6. Place the designation card that you have filled out over the buttons, and
then replace the clear cover by gently bending the cover so that the tabs at
the top and bottom end of the cover can be inserted into the corresponding
slots on the housing of the voice terminal. See
Figure 5
.
Summary of Contents for Definity Callmaster IV
Page 2: ......
