◇
When the working mode of the knob is Aftertouch, below settings are available to
change:
①
MIDI Channel for the knob.
②
The value range of the knob to send Aftertouch.
③
Aftertouch could be set to KeyAftertouch or Channel Aftertouch.
2.Modify pad parameters
In the MENU, hit the pad to get to the corresponding pad setting interface, use the
[UP] and [DOWN] buttons to select parameters, and then use the selection knob to
modify the parameter values.
The working mode of the pad can be changed:
◇
When the working mode of the pad is Note, the pads can trigger drum hits or other
sound samples in your software. Below settings are available to change:
①
MIDI Channel of the pad.
②
MIDI notes of the pad.
③
Velocity curve of the pad.
④
Aftertouch of the pad could be set to Key Aftertouch or Channel Aftertouch.
◇
When the working mode of the pad is CC N, every time the pad is triggered, it will
send a CC command. Below settings are available to change:
①
MIDI Channel of the CC command.
②
The value of CC command.
◇
When the working mode of the pad is CC Toggle, the value of Toggle on/off
commands would be sent out from the keyboard circularly each time the pad is
triggered.Below settings are available to change:
①
The MIDI Channel of the CC command.
②
The CC value of the CC command.
③
The value of Toggle on and Toggle off.
◇
When the working mode of the pad is CC Momentary(CCM), the value of Pressed/
Released commands would be sent out from the keyboard every time the pad is
pressed/released. Below settings are available to change:
①
The MIDI Channel of the CC command.
②
The CC value of the CC instruction.
③
The value of Pressed and Released.
◇
When the pad working mode is Program Change, below settings are available to
change:
①
The MIDI Channel of Program Change.
②
The value of Program Change.
3.Modify the parameters of joystick
In the MENU, move the joystick up and down or left and right to get to the joystick
setting interface, use the [UP] and [DOWN] buttons to select parameters, and then use
the selection knob to modify the parameter values.
