8.Arpeggiator
◇
Press the [ARP] button to turn on the arpeggio function, and the [ARP] indicator
lights up; press [ARP] again to turn off the arpeggio function, and the [ARP]
indicator turns off.
◇
Holding down the [ARP] button, then press certain key on the keyboard will modify
the parameters of the arpeggiator according to the description above that key;
◇
When using the built-in metronome, hold down the [ARP] button and use the
selection knob to modify the speed of the built-in metronome.
9.Note Repeat
The Note Repeat function only works when the pad is set to Note.
◇
Press the [NOTEREPEAT] button to enable the Note Repeat function for the pads,
and the [NOTEREPEAT] indicator lights up; press the [NOTEREPEAT] button again
to turn off the Note Repeat function, and the [NOTEREPEAT] indicator goes off.
◇
When the Note Repeat function of the pads is enabled, press and hold the pad, the
pad will repeatedly send the MIDI code value of the pad according to the note
length and velocity parameters set by the arpeggiator, and the velocity value is the
strength you currently press the pad.
10.BANKA/B
◇
The corresponding pads of group A are PAD1-PAD9; the corresponding pads of
group B are PAD10-PAD18.
◇
Press the [BANKA/B] button to switch the pads to group A (orange indicator light)
or group B (green indicator light).
11.Wireless connection function
Press the wireless connection button to turn on the wireless connection function;
press the button again to turn off the function.
After the wireless connection function is turned on, the indicator light blinks. At this
time, you can use mobile phones, computers and other devices to search for "MIDI
keyBoard-01" and make a connection. After the keyboard connected to your device,
the wireless connection indicator light is always on.
12.PedalInterface(SUSTAIN)
When a pedal is connected, MIDI messages are sent when the pedal is operated.
PRESET PARAMETER EDITING
1.Modify Assignable knob parameters
In the MENU, turn the Assignable knob to the setting interface of the corresponding
knob, use the [UP] and [DOWN] buttons to select aparameter, and then use the
selection knob to modify the parameter value.
The working mode of the knob can be modified:
◇
When the working mode of the knob is CC command, below settings are available to
change:
①
MIDI Channel for the knob;
②
MIDI controller numbers for the knob;
③
The value range for the MIDI CC message.
