OPERATIONAL INSTRUCTIONS
13
USING THE FITNESS METER
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AA batteries, the batteries are not
included. Refer to the illustration to install or replace the batteries.
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
NOTE:
CALORIE:
TIME:
DISTANCE:
ODOMETER:
PULSE:
POWER OFF:
HOW TO INSTALL AND REPLACE BATTERIES:
AA Batteries
Automatically scans
SPEED, DISTANCE,
TIME, ODOMETER, CALORIE,
and
PULSE
in sequence with a change every six seconds.
Press and release the
MODE
button until the
arrow points to
“SCAN”.
NOTE:
Pedal movement or push the
MODE
button.
Automatic shut off after 4 minutes of inactivity.
POWER ON:
FUNCTIONS:
MODE BUTTON:
Press and release to select functions.
Press and hold for three seconds to reset
all functions to zero, except
ODOMETER
.
Displays the current speed, from zero to 999.9 Mile/Hr.
Displays distance, from the time the meter is turned on, to 999.9 miles.
Displays the time, from 1 sec. up to 99:59 minutes.
Displays the total accumulated distance you have traveled, from zero to 999.9 miles. The
total accumulated distance is retained when the meter is turned off.
Displays the calorie consumption, from zero to 999.9 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a
comparison between workouts on this unit.
Displays your pulse rate in beats per minute. To display pulse, select the PULSE MODE
and grasp the pulse sensors on the handlebars, one in each hand. The heart icon will
begin flashing when the ELECTRONIC METER senses your pulse. Your pulse will be
displayed approximately five (5) seconds after the heart icon is displayed. If the heart icon
does not appear, relax your grip or change your grip on the pulse sensors.
SPEED:
The function mark
“M”
in bottom-right on the LCD display means the electronics reading is
in Miles. A
“K”
indicates Kilometers. To change the function mark from
“M”
to
“K”
or
“K”
to
“M”
, press the
MODE
button and hold it down for five seconds until the second beep.
The meter will shut off automatically after 4 minutes of inactivity. All function values will
be kept. Press the
MODE
button and hold it down for three seconds to reset all functions
to zero, except
ODOMETER
.
The
ODOMETER
will be reset to zero after batteries are removed for battery replacement
or storage of the unit.
1.
2.
3.
SCAN:
Meijer.com
