CHAPTER 5
Instructions, use and maintenance manual
D r a g o P Z e r o
Page 29
5. TRANSPORT AND INSTALLATION
5.1. INTRODUCTION
CAUTION!
Lifting and handling must only be done by specialised and trained personnel, who are qualified to
perform these activities.
To handle the machine, respect the indications and pictograms shown, using suitable tools and
equipment.
During installation, the AVANZINI BRUCIATORI s.r.l. technicians must be assisted by operators who are assigned
for future maintenance and operation of the machine.
The machine was designed in such a way as to not require the use of equipment such as cranes, gantries or
forklift trucks during the packaging, transport and assembly phases.
5.2. PACKAGING
Depending on the transport distance, on the Customer’s specific requests and on the amount of time that the load
will stay packed, the machine is shipped as follows:
• protective packaging with polyethylene bubble sheets without base, for short and medium distances;
• protective packaging, securing the machine on a wooden base (with protective crate if necessary) for long
distances.
In case the packing is secured to the base, the machine will be secured to such base by means of metal brackets,
which must be removed before handling the machine.
Shipment must be made using covered or sheeted transport means depending on the type of load.
CAUTION!
Before opening the packaging, its integrity must be checked and any anomalies must be
communicated to AVANZINI BRUCIATORI s.r.l.
Upon receipt of the machine, the customer must verify that there are no damages caused by the method of
transport or by the personnel in charge of the specific operations.
In case damages are ascertained, leave the packaging in question as found and immediately request assessment
of the damage by the competent shipping company, and then with a surveyor's report, inform the competent
transport insurance company and the seller.
After having checked machine integrity, the fastening screws in the wooden base can be removed to then proceed
with handling as instructed in the next paragraph.
All the packaging material must be kept for any future transport.
In particular, if there is a wooden base and/or crate, brackets fastening the machine to the packaging must also
be carefully kept in addition to the base itself.
The material must be stored in a suitable place so that it is not subject to deterioration, which could dangerously
reduce the capacity of the package structure (e.g. weakening of the timber due to constant humidity or parasites).
