37
Installation Manual
CAUTION!
Wear protective gloves
when handling wires.
1.5.1 Traction wire rope installation
a) Remove protection guard above rollers.
b) Feed the traction wire rope through the roof
into the traction hoist’s wire rope inlet opening.
(Right side seen from front of lift).
c) Push the UP button on the pendant control and
feed wire rope through until the traction hoist
starts pulling. Ensure that the wire rope can exit
without obstruction!.
d) Continue feeding the wire rope underneath
(round) the front guide wheel, over the back
guide wheel, and through the back panel.
e) Let the lift wire rope pass through until it is
slightly tightened.
f) Replace roller protection guard.
g) Feed traction wire rope through platform floor.
1.5.2 Safety wire rope installation
a) Remove protection guard above rollers.
b) Open the fall arrest device by pushing down
the lever until it engages/clicks (Fig. 16 “Regulation
of overload limiter” Appendix). Feed the
safety wire rope through the roof hole above
the fall arrest device and continue by feeding
through the fall arrest device.
c) Like the traction wire rope, continue feeding
the wire rope underneath (round) the front
guide wheel, over the back guide wheel, and
through the back panel.
d) On the back of the lift pull the safety wire rope
to tighten it.
e) Replace roller protection guard.
f) Feed safety wire rope through platform floor.
Fig. 11
ASL508
1.5 Installation of traction and safety wire ropes through lift
Traction wire rope
contra weight
Safety wire rope
push spring
Locked
Unlocked
AT00016288 Shark L AECO EN update.indd 37
11/14/2018 4:02:55 PM
