ID
:
020393
Revision:
1-00
5
© Avantes BV
CC connection
Position to insert CC-VIS/NIR of the system to be calibrated. CC can be locked with an allen screw.
I/O connector
For automatic disable control to be controlled by software it is needed to connect an AvaSpec
spectrometer to the AvaLight-HAL-CAL-Mini with the interface cable IC-DB26-2.
The signals on the I/O connector are described below.
Pin configuration
Pin Name
Description
8
Vout
Output
Nominal 12VDC output
10
GND
Ground
11
Disable
Input
Input, used to disable/shut down the output
Below the electrical characteristics for the input signals.
Electrical characteristics
Name
Low level detection High level detection Maximum voltage
Disable
< 1.0V
> 2.0V
13.2V
2.2
12VDC Power plug
The power supply specifications are mentioned in the table below
Name
Minimum
Typical
Maximum
Voltage
10V
12V
15V
Power
18Watt
2.3
Settings for disable
With the disable function that is present on the I/O connector the user can disable the optical
output of the light source by setting this signal to high-level.
When the light source is used in combination with an AvaSpec spectrometer, interface cable IC-
DB26-AvaSphere-0.5 and AvaSoft, the output can be disabled or enabled by AvaSoft.
See appendix A.
Summary of Contents for AvaLight-Hal-CAL-Mini
Page 1: ......
