ID
:
020407
Revision:
1-00
7
© Avantes BV
3
Replacement of Deuterium or Halogen Lamp
Warning
:
Make sure the Deuterium Lamp is switched OFF before disconnecting the power cord.
Before re-connecting the power cord, make sure that the power switch, the Deuterium lamp and
the Halogen lamp switch are switched off.
Warning:
During operation the lamp envelope reaches a temperature of approx. 250°C. Should you intend to
change the lamp please wait for at least 20 minutes for cooling before touching the lamp. The lamp
envelope (quartz glass) should not be touched with bare fingers, otherwise lifetime will be severely
reduced.
Please follow these instructions for the bulb replacement:
1.
Switch off the light source and disconnect the unit from the mains power supply.
2.
Remove both side covers by unclicking.
3.
Remove the 4 screws securing the top cover by using a torx screwdriver to remove the top
cover.
4.
Disconnect the deuterium power connector.
5.
Dismount the front panel by unscrewing the 4 front screws.
6.
Carefully slide out the front panel until the green connector is visible and disconnect the
connector of the switches.
7.
Turn the light source upside down and carefully slide out the front panel.
Switch
connector
Deuterium
connector
Summary of Contents for AvaLight-D-S
Page 1: ......
