24 (28)
.
7.2
Cleaning the attachment
Clean the attachment regularly to prevent accumulation of dirt which is more difficult to remove. A pressure
washer and mild detergent can be used for cleaning. Do not use strong solvents, and do not spray directly at
the hydraulic components, or at the labels on the attachment.
7.3
Checking metal structures
Also the metal structures of the attachment must be inspected regularly. Check visually for damages and
inspect the quick attach brackets and their surrounding area carefully. The attachment must not be used if it is
deformed, cracked, or torn.
Welding repairs are only allowed to be carried out by professional welders. When welding, only methods and
additives suited for steel used in bucket must be used. For more information about repairs contact your
nearest service point.
7.4
Lubrication
There are a total of 10 lubrication points at the joints of the attachment. A small amount of grease should be
added regularly.
Suitable lubrication interval depends heavily on operating conditions but lubricant must be added at least
after every 10 hours of use. Adequate lubrication of the joints must be ensured, and if the joints have become
dirty, lubricant must be added; added lubricant will push out dirt from joints.
Clean the end of the nipple before greasing and add only a small amount of grease at a time. All lubrication
nipples are standard R1/8" nipples. Replace any damaged nipples.
