AVANT A36299, Operator'S Manual For Attachment

Page: 16 / 28

16 (28)
Releasing residual hydraulic pressure:
In case residual pressure is left in the hydraulic system of the attachment, it is often possible to disconnect the
hydraulic couplings, but it may be difficult to connect them the next time. If the fittings will not connect, the
residual pressure must be released by turning the auxiliary hydraulics control lever of the loader, when the
engine is turned off. To make sure that there will not be residual pressure in the hydraulic system of the
attachment, shut down the loader engine and move the auxiliary hydraulics control lever of the loader back
and forth before disconnecting the couplings.
5.2 Transport position
CAUTION
Keep the loader stable. Always
transport the silage forks as low and
close to the ground as possible.
Keep the telescopic boom retracted
during drive.
5.3 Storing the attachment
Uncouple and store the attachment on level ground. The best way to store the attachment is a place where it
is protected from direct sunlight, rain, and extreme temperatures.

Avoid leaving the attachment laying directly on the ground. Place it on blocks of wood or on a pallet, for
example.

Place the multiconnector on to its holder. Never leave the hydraulic connector on the ground.

Make sure that the attachment is secured against all movements during storage.
Never climb on the attachment.
For longer storage periods touch up the paint where needed, grease the lubrication points and oil the visible
parts of the hydraulic cylinder shaft to prevent rust damage.