Over Armour Offroad
2505 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Kawasaki
Mule SX
Soft Door Kit
KAW-SX-SDK01
CAUTION: Do not smoke inside the cab or expose the enclosure to direct flames. Product is
FLAMMABLE.
Be sure to read these instructions thoroughly before opening and installing the enclosure.
The installation is best done when the temperature is 60
°
F or warmer.
Carefully open the
carton and unroll the enclosure on a large flat surface that is clean and free of dirt or other
material.
Check over the parts included in the carton with the parts list shown below:
Velcro hook strips
24 each
3” long
Velcro hook strips
2 each
8” long
Velcro hook strips
2 each
19” long
Snap Studs
17 each (1 extra)
Cab Enclosure
2 doors
1.
You must remove the windshield and top(if installed) before beginning
installation of the Soft Door Kit.
2.
Begin by attaching the top of the door to the cross bars running front to back on
the roll cage using the supplied 19” adhesive Velcro strips. Pull the door up and
mark where the Velcro on the top of the door is going to hit the bar, make sure
that the cab is centered across the back by checking both sides and making sure
they both hit the front bars equally. Now apply the 19” adhesive Velcro on the bar
facing inboard, and attach the corresponding Velcro straps on the enclosure(see
fig. 2
