525 LPG
Load diagram
The lifting capacity of the loader is limited by the possibility of tipping around the front axle. The diagram
below shows the tipping loads and max. allowed loads in different loading situations on an even level surface
with the loader chassis in maximum articulation.
Description of the loader
11
525 LPG
525 LPG
Tipping load with the loader in
max. articulation
Rear weight 170 kg, Driver 75 kg
Max. load, ISO 14397-1
The loader in max. articulation
Rear weight 170 kg,
Driver 75 kg
Distance from front axle mm
AVANT 525LPG load diagram
0
5
10
15
20
25
30
35
40
15
00
16
00
17
00
18
00
19
00
20
00
21
00
22
00
23
00
24
00
25
00
26
00
27
00
28
00
29
00
30
00
31
00
32
00
33
00
34
00
35
00
36
00
rpm
l/min
1 pump
2 pumps
The diagrams can be interpreted as follows:
The diagrams show tipping load and max. load with
the load at different distances
from the front axle of the loader
Example: If the center of gravity of the load is 750
mm in front of the front axle, max. load is about 700
kg with a driver weighing 75 kg and with the 170
kg integrated rear weight mounted on the loader.
NOTICE:
If the driver leaves the machine, tipping
and max. loads are reduced respectively.
Tipping load and max. load depend both on the
weight of the driver and the eventual extra weights
mounted on the loader.
Please note that the diagrams are based on the
machine operating on a level, even and firm
supporting ground. Loads should be significantly
reduced when operating on gradients and/or on soft
ground.
The loader is equipped with a load sensor system,
which gives an audible warning signal and an indicator
lights up in the dashboard when tipping load is being
approached.
Read the safety instructions regarding handling of
heavier loads. Calibration instructions of the load
sensor system can be found on page 30.
Auxiliary hydraulics oil flow
Max. auxiliary hydraulics oil flow can not be used with all attachments. Check correct engine
rpm and auxiliary hydraulics pump configuration for the attachment with the help of this table
and Operators Manual of the attachment.
