3 6
Optional Equipment
Travis Industries
4050504
1 0 0 - 0 1 1 5 4
Thermostat (Part # 99300650)
!
Do not connect 120 VAC to the thermostat circuit
of this heater (do not use a household thermostat
used for a wall-board or other electrical heater).
1
Attach the thermostat wire to the circuit board.
Route the thermostat wire through the hole in the
rear panel (make sure to leave enough slack to
allow the control panel to open).
2
Determine a location for the thermostat that is
within range of the 50' length of thermostat wire. It
should be centralized in the room and away from
the heater. The wire may be routed externally on
the wall or behind the wall (preferred).
3
Follow the directions below to attach the
thermostat and thermostat wires.
Attach the quick-
connects to the
thermostat posts
on the circuit
board (orientation
does not mater).
50 60 70 80 90
50 60 70 80 90
Robertshaw
Run the thermostat wires
through the wall (cut off excess
wire, leaving 6” of slack).
Pull the cover off the thermostat
Expose 1/2” of wire and
attach to these two posts.
Standard
Screwdriver
Attach the thermostat to
the wall through these
two holes.
Summary of Contents for Astoria 2003
Page 2: ......
