10.3.Power Cable Connection
10.4.Signal cable connection
Chapter - 10
10.4 Display power cable connection
1. Install the power distribution cabinet and install it near the screen according to the
site conditions to avoid the main power cable being too long.
2. Install the cabinet, refer to Chapter 10.
3. After the cabinet is installed, connect the power cord according to the design
drawings.
Picture 5-2 shows the connection of the power cable of the CR OR Series display.
Power Distribution Box Picture 5-2.
Main power cord Picture 6-1.
Cabinet power cable Picture 6-3.
10.5 Signal cable connection
10.5.1 Sending box
：
The sending box contains a sending card to send video data to the display.
10.5.2 Main Signal Cable
：
Send the main signal cable between the cabinet and the display screen to transmit
video data with a length of less than 70m.
Remarks: When the transmission distance is greater than 70m, it is possible to
transmit data by optical fiber, and the longest distance is 20 kilometers.
Cabinet signal cable: used for signal transmission between cabinets.
10.5.3 Display Signal cable connection
：
1. Install the sending box, arrange the main signal, and put it next to the display
installation position.
2. Install the cabinet, refer to Chapter 10.
3. After the cabinet is installed, connect the signal wires according to the design
drawings.
Picture 5-1. shows the signal cable connection of the CR OR Series
Each main network cable carries maximum 650.000 pixels.
Sending box Picture 7-2.
Main signal cable Picture 6-2.
Cabinet signal cable Picture 6-5.
Remarks:
The number of pixels carried on each main network cable of the sending box is limited,
and the actual project should refer to the corresponding signal connection diagram.
Per Signal cable Max: 650.000Pixel
Picture 5-1. Signal Connection Diagram
checking products software manuel
