OPERATING INSTRUCTIONS.
6.
NOTE
THE TEFLON SHEET SHOULD BE INSTALLED PRIOR TO FITTING THE CONVEYOR CASSETTE AS
DESCRIBED ABOVE. IT IS RECOMMENDED THAT A LIGHT COATING OF EDIBLE OIL IS APPLIED TO THE
GRILL PLATE PRIOR TO FITTING THE TEFLON SHEET
NOTE:
THE TOASTED COLOUR OF THE BUN CAN BE ADJUSTED LIGHTER OR DARKER BY USING THE
TEMPERATURE CONTROL OR THE SPEED CONTROL OR A COMBINATION OF BOTH. WHEN
OPTIMUM BUN COLOUR AND SPEED HAVE BEEN ACHIEVED IT IS RECOMMENDED A NOTE IS TAKEN
OF THE SETTINGS FOR FUTURE REFERENCE.
INSTALLATION OF OPTIONAL TEFLON SHEET .
1.
Lay the Teflon sheet on a flat surface and measure approximately 2’’ from the end of the
sheet. Notch the corners at 45 degrees as needed and fold a flap 2’’ long.
Carefully crease the flap at the 2’’ fold.
2.
Remove the bun feeder chute (7). From the rear of the Teflon sheet retainer bracket slip
the 2’’ fold under the bracket. Bring the balance of the sheet forwards and smooth the
sheet down against the grill plate.
3.
Reinstall the feeder chute.
C.
1.
Thoroughly clean the unit as described in the cleaning section of this manual on page 7.
2.
Turn on the main switch the conveyor will now run.
3.
Set the temperature to approx. 400F which equates to 5.7 on the scale. If using the optional
Teflon sheet it is advisable to increase the temperature setting to approx. 450F which
equates to 6.5 on the scale
(1-85F, 2-140F, 3-200F, 4-285F, 5-350, 6-410F, 7-480F).
4.
Any high-quality edible oil can be used with this bun toaster. It is preferable to use oil
specifically suited for use in toasters.
5.
The pilot cycle cycles with the heating element and indicates when the heater is on. It is
preferable to wait until the unit has reached operating temperature and the light has cycled
on and off twice.
6.
Heat the toaster oil to melting point and carefully fill the butter tray 2/3 full. Turn on the
butter roller using the switch provided.
7.
Hold the bun half in the palm of the hand and in one motion slide the sliced side of the bun
onto the butter roller. Drop the bun with the sliced surface towards the grill plate using the
feeder chute provided. See diagram C.
8.
The toasted bun will drop out into the receiving tray at the bottom of the unit.
