CONVEYOR ADJUSTMENT.
CLEANING & MAINTENANCE
7.
NOTE:
THE UNIT MUST BE DISCONNECTED FROM THE POWER SOURCE AND ALLOWED TO COOL DOWN
BEFORE CLEANING TAKES PLACE.
1.
All of the removable panels can be cleaned either in a sink with hot water and detergent or
placed in a dishwasher.
2.
It is recommended the conveyor cassette is only cleaned in a sink with regular detergent.
Make sure the chains are lubricated after cleaning with a suitable toaster oil.
3.
The grill plate can be cleaned can be cleaned with a suitable grill plate scourer. After drying a
light film of toaster oil should be applied.
If optimum bun grilling is not achieved using the speed and temperature settings it is possible to
adjust the position of the conveyor system relative to the grill plate. Moving the conveyor closer to
the grill plate will apply more pressure to the bun and result in more effective toasting.
1.
Switch off the unit and allow to cool down.
2.
Remove the butter roller and tray and feed chute.
3.
Remove the top panel and the bottom panel.
4.
Remove the conveyor cassette carefully by lifting up and pulling towards the front
N
OTE:
THE CONVEYOR IS HEAVY AND MUST BE HANDLED CAREFULLY.
5.
The hanger adjustment brackets will now be exposed. Loosen the brackets and move
them EQUALLY towards the grill plate in increments of 1/8”. See diagram D.
6.
Retighten the bracket screws.
7.
Adjust the drive gear engagement as needed with the bolts at the bottom of the hanger
plate.
Ensure that the lock nuts are retightened.
1
2
1
3
4
5
6
7
8
8
screws
D.
adjustment bracket
