Help: 888-426-5001
QualityWaterForLess.com
F I G u R e 11- C
F I G u R e 11- d
F I G u R e 11- e
F I G u R e 11- F
6 ›PRo G R a m m I n G t H e au tot Ro l 2 5 5 / 76 0 Va lV e
1) Before programming may begin, the power cord must
be connected to the 760 timer on your valve. Begin
by locating the small locking tab to the left side and to
the rear of the timer as shown in Figure 11-A. Release
the tab by pushing down on it and allowing the timer
assembly to swing outward
2) Locate the included transformer power pack, and
string the male end of the cord under the timer brack-
et and into the timer. Attach the cord to the valve by
tracing the other cables as shown in Figure 11-B
5) Next is the
Time of day
. Press the
SeT
button
to enter edit mode. Use the
UP
or
dOWn
buttons to change to the current time of day.
i
note that there is a difference between
“AM” and ”PM.”
Then press the SET button to
make this setting active (Figure 11-E)
6) Next is the
day of the Week
. Press the SET
button to enter edit mode. Use the UP or DOWN
buttons to change to the current day of the week.
Once the time has been changed, press the SET
button to make this setting active as shown in
Figure 11-F
3) The timer will show “
- . - -
“ as shown in
Figure 11-C. If this does not show up initially,
your system has been pre-set and you may skip
ahead to the next section, initial start-up
4) Use the
UP
arrow button to input the number
corresponding to your
tank size
as shown in
Figure 11-D. Find your tank size by dividing your
grain capacity by 32,000 (EX: 64,000 / 32,000 =
2.00). Press the
SQUARe / SeT
button to make
this setting active. If you need to reset this,
steps to reprogram are found on page 2
F I G u R e 11- a
F I G u R e 11- B
