AUTOTECH AT-8070-D, Installation And Programming Manual

Page: 7 / 8

OPERATION TIME PROGRAMMING FOR SINGLE LEAFED SWINGING GATE WITH SLOW SPEED
Set trimmer TORQUE at minimum needed to move the door leaf correctly and adjust trimmer for slow speed
at minimum needed to move the door correctly .
Totally close the door.
When you want to start slow speed press START: Slow speed mode has began.
When the door is totally open press START: The door closing at normal speed.
When you want to start slow speed for the door press START: Slow speed has began.
When the door is totally closed press START.
Wait until the TEST LED turns off.
The operation time programming is complete.
Ÿ
The next time the door will open will be according to the settings just completed.
ATTENTION:
After RESET or power supply failure, at the first closing of the door the operation time will be greater
(approximately 12 seconds)
Ÿ
Ÿ
Ÿ
Press PROGR until starts blinking and do not release PROGR until starts blinking faster.
Ÿ PROGR
Ÿ The door starts moving at normal speed.
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
SLOW
TEST LED TEST LED
Release
Press
START:
M1
2
START
M1
4
START
First START command initiates
the operation time programming
causing the door to OPEN.
Second START command defines
the starting point for slow speed
for the door while opening
Third START command defines
the end of door operation time
and must be issued when the door
totally opens
Fourth START command defines
starting point for slow speed for the
door while closing.
Fifth START command defines
the end of the door operation
time and must be issued
when the door totally closes.
OPERATION TIME PROGRAMMING FOR SINGLE LEAFED SWINGING GATE WITHOUT SLOW SPEED
Ÿ
at maximum needed to move the door correctly .
Ÿ
Totally close the door.
Ÿ
Press PROGR until TEST LED starts blinking and do not release PROGR until TEST LED starts blinking faster.
Ÿ
Release PROGR
Ÿ
Press START: The door starts moving at normal speed.
Ÿ
When the door is totally open press START: The door closing at normal speed.
Ÿ
When the door is totally closed press START.
Ÿ
Wait until the TEST LED turns off.
Ÿ
The operation time programming is complete.
Ÿ
The next time the door will open will be according to the settings just completed
ATTENTION:
After RESET or power supply failure, at the first closing of the door the operation time will be greater
(approximately 12 seconds)
Set trimmer TORQUE at minimum needed to move the door leaf correctly and adjust trimmer for slow speed SLOW
.
.
M1
1
START
M1
2
START
M1
3
START
First START command initiates
the operation time programming
causing the door to OPEN..
Third START command defines
the end of the door operation time
and must be issued when the door
totally opens
Third START command defines
the end of the door operation
time and must be issued
when the door totally closes
M1
1
START
M1
3
START
M1
5
START
7