P.10
User Guide
Note: The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter
to zero and allow the engine to run for another cycle (in this case, 3 minutes).
Disable/Enable
LED
flashing
To disable the LED: Press
and
simultaneously until the remote beeps once, pause for 2
seconds, then beeps once again. Release the buttons. The parking lights will flash three times.
To Enable the LED: Press
and
simultaneously until the remote beeps once, pause for 2
seconds, then beeps once more. Release the buttons. The parking lights flash once.
Constant
output
Pressing and holding the
button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the
button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling up the windows – Please
refer to your installer to see if your vehicle is compatible with this option.
Pressing and holding the button for more than 3 seconds will unlock all doors and will send a
constant pulse as long as the button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling down the windows –
Please refer to your installer to see if your vehicle is compatible with this option.
Feature
Confirmation
Chart
Feature
LOCK
UNLOCK
TRUNK
START/STOP
Beep(s)
Lock 3
flashes X
X
X
1
Unlock X 3
flashes X
X
2
Trunk X X
3
flashes
X 1
LED ON/OFF
3 flashes
3 flashes
X
X
1
Start X X X
3
flashes
1
Running X X X
3
flashes
3
Stop X X X
3
flashes
2
Entering Cold
Weather Mode
X X X
3
flashes
2
Exiting Cold
Weather Mode
X X X
3
flashes
1
Home Valet
3 flashes
X
X
3 flashes
2
Valet Mode
3 flashes
X
X
3 flashes
1
Exit
ValetMode X 3
flashes X 3
flashes 1
Fail Start Attempt
X
X
X
4 flashes
4
