AS-2510 TW
Installation Guide
P. 13
FUNCTION 3 –
AUX 2
Programming
OPTION 1
Constant output while the
LOCK
and
UNLOCK
buttons are pressed.
In Safe Start Mode: activate
AUX 2
by pressing the
START
button.
OPTION 2*
Toggle
ON/OFF
(with 30-second timeout)
OPTION 2
Toggle
ON/OFF
(with 60-second timeout)
OPTION 4
Priority Door Access
FUNCTION 4 –
AUX 1
Programming
OPTION 1
Horn Confirmation upon the 2
nd
press of the
LOCK
button.
OPTION 2*
Priority Door Access
OPTION 3
Horn Confirmation upon the 1
st
press of the
LOCK
button.
FUNCTION 5 – External Trigger
OPTION 1
Zone 3 rearm (Trunk Pin: a disarm pulse is sent before the Trunk opens,
the vehicle rearms 4 seconds after the Trunk is closed).
OPTION 2*
Engine Start/Stop
OPTION 3
Key Sense
OPTION 4
Smart Ignition Re-Lock
Tach Programming
About Tach Programming
If you press the
START
button before carrying out a Tach Programming procedure, the
Remote Car Starter will make no attempt to start the Engine and the Parking Lights will give
5 flashes.
If order to carry out Tach Programming, you may simply follow the Automatic Tach
Programming procedure.
The Remote Car Starter stores Tach settings regardless of the procedure used at the time
of Tach programming. All Tach settings are cleared when the Remote Car Starter is reset. A
new Tach Programming procedure has to be carried out
only
if the Remote Car Starter is
reset.
Multi-speed Tach Programming
Tach signals may vary from vehicle to vehicle. The Remote Car Starter is designed to read
a wide range of Tach signals produced by recent Ignition systems. There is no necessary
manual adjustment. Nevertheless, a Tach-programming procedure
must
be carried out
every time a new Remote Car Starter Unit is installed
. This is because the Tach signals
of certain Ignition systems are sometimes too low or too high for the Remote Car Starter,
causing failed start-ups at various temperatures.
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2. Press and hold the
Brake Pedal
,
– And simultaneously press the
LOCK
and
UNLOCK
buttons on the Transmitter:
– The Parking Lights will flash 4 times.
– Release the Brake Pedal.
3.
Start up the Engine
and allow the vehicle to reach regular Engine idle speed.
4. Once the Engine is running idle, press the
Brake Pedal
and keep it down until you
hear the Parking Lights Output flash 5 times.
– Release the Brake Pedal: Tach Programming is now complete.
Table 5: Multi-speed Tach Programming