User Guide
P.
9
Secure Lock
Before it can remote-start your vehicle, the remote starter must first disarm the factory security
system. The secure lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, secure lock will rearm your factory security system.
Remote Trunk Release
If your system was installed with the remote trunk release option, you can open your trunk by
pressing the
TRUNK
button. There will be one beep and LED #3 will flash 3 times.
The Starter Kill and the Anti-grind Feature
With this added security feature, the system will prevent your vehicle from starting with the ignition
key when the starter kill is armed. If your remote starter was installed with the starter kill option,
one will not be able to start your vehicle with the key unless the system has been unlocked and
disarmed first, or put into valet mode.
Note: If the starter kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the
CRANK
position.
Safe Start
If this feature is enabled, the user must press the
START/STOP
button 2 times within 3 seconds to
remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
If swap start mode is selected, to remote-start your vehicle, press the
SHIFT
button and then the
LOCK
button. The
AUX 2
output can be activated by pressing the
START/STOP
button.
Valet Modes
Valet Mode Using the Valet Switch (if installed)
To put the system i n t o valet mode:
1. Turn the ignition key to the
IGNITION ON (RUN)
position.
2. Within 3 sec., press the valet button.
The parking lights will flash three times to indicate that the vehicle is now in valet mode.
3. Turn the ignition key to the OFF position.
The L.E.D. will come
ON
solid.
To take the system o u t o f valet mode:
1. Turn the ignition key to the
IGNITION ON (RUN)
position.
2. Within 3 sec., press and release the valet button.
The parking lights will flash twice to indicate that the vehicle is now out of valet mode.
3. Turn the ignition key to the OFF position.
The L.E.D. will go out.
Note: Once valet mode is activated, the remote starter functions will be disabled.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the home valet mode is activated, the vehicle will not start by remote.
