INSTALLING THE BATTERIES
Your
Home Producer 8 requires four (4) new AAA
alkaline batteries. To install the batteries:
1
On the back of the
Home Producer
8, press down on the black battery
cover near the indentation where
the black and silver sections meet
and push/slide the cover off (see
illustration).
2
Match the + and - marks on the
batteries to the + and - marks in the
battery case, then insert the
batteries.
3
Slide the battery cover back into
place.
4
Test the unit by pressing POWER.
If the batteries are inserted correctly,
the red light will blink.
NOTE: Immediately before removing the batteries, please refer to
page 8 and re-enter your TV's setup code. This will allow the Home
Producer 8 to retain its memory upon removing the batteries. If you
do not, upon entering your fresh batteries, the LCD screen may say
[MEM FAULT]. If [MEM FAULT] does appear on the LCD screen,
press and hold MAGIC until the display screen changes from [TV and
the TIME] to [TIMED SEQ]. Press the MENU - key one time. The
display screen will change to [CODE SET UP]. Press SELECT. The
display will change to [DEV SET UP]. Press SELECT and the display
screen will change to [TV]. Enter code 9-6-1. Press SELECT. Now
press and hold MAGIC until the display screen changes from [TV and
the TIME] to [TIMED SEQ]. Press the MENU + key one time. The
display screen will change to [CONFIGURE]. Press SELECT. The
display screen will change to [THEATR SEL]. Press MENU + once.
The display screen will change to [SERVICE]. Press SELECT. The
display screen will change to [MFG RESET]. Press SELECT. The
display screen will change to [SEL TO RS]. Press SELECT. The
display screen will then return to [TV and the TIME].
POWER
URC 8090
Home Producer
User Manual
