37
UK
11.5 Output response in different operating states
OUT1
OUT2
Initialisation
OFF
OFF
Normal operation
according to the level and
OU1 setting
according to the level and
OU2 setting
Fault (E�0xx)
OFF for FOU1 = OFF;
ON for FOU1 = on
4 mA / 0 V for FOU2 = OFF
20 mA / 10 V for FOU2 = on
12 Technical data and scale drawing
Technical data and scale drawing at www�autosen�com�
12.1 Setting ranges
[LEnG]
cm
inch
Setting range
10���100
4�0���39,4
Step increment
0�5
0�2
[OFS]
cm
inch
Setting range
0���100
0���39�4
Step increment
0�5
0�2
The setting ranges for the switching limits (SP1, rP1, FH1, FL1) depend on the
probe length (L)� In general the following applies:
cm
inch
min
max
min
max
SP1 / FH1
1�5 (3�5)
L - 3
0�6 (1�4)
L - 1�2
rP1 / FL1
1�0 (3�0)
L - 3�5
0�4 (1�2)
L - 1�4
Step increment
0�5
0�2
The values apply if [OFS] = 0� The values in brackets apply to the setting
[MEdI] = [LOW] (setting for the detection of oils and oil-based media)�
• rP1 is always lower than SP1. If the value for SP1 is reduced to a value ≤ rP1 the position
of rP1 also shifts�
• If rP1 and SP1 are close together (about 3 x step increment), rP1 is changed automatically
when increasing SP1�
• If there is a greater difference between rP1 and SP1, rP1 maintains the set value even if
SP1 is increased�
