29
UK
10 Parameter setting
During parameter setting the unit remains in the operating mode internally� It
continues to monitor with the existing parameters until the parameter setting has
been completed�
10.1 Parameter setting in general
3 steps must be taken for each parameter setting:
1
Select parameter
► Press [Mode/Enter] until the
requested parameter is displayed
.
2
Set parameter value
► Press [Set] and keep it pressed�
> Current setting value of the
parameter flashes for 5 s�
> After 5 s: setting value is changed:
incrementally by pressing the button
once or continuously by keeping the
button pressed�
Numerical values are incremented continuously� For reducing the value: let the
display move to the maximum setting value� Then the cycle starts again at the
minimum setting value�
3
Acknowledge parameter value
► Briefly press [Mode/Enter]�
> The parameter is displayed again�
The new setting value is saved�
Setting of other parameters:
► Start again with step 1�
Finishing the parameter setting:
► Press [Mode/Enter] several times until the current measured value is displayed or wait
for 15 s�
> The unit returns to the operating mode�
[S.Loc] is displayed (→ 11.1).
