Autoscript ClockPlus, User Manual

Page: 17 / 33

15
Installation
Alternative Tally Connections
The tally indication status of the TallyPlus and ClockPlus can be
controlled by alternative control connection methods, if this is a
requirement of the installation.
Shorting Plug for Constant Red Display
If a permanent red display is required on the
ClockPlus or the TallyPlus, insert a shorting
3.5mm mono jack plug into the Tally Opto
Sensor IN socket.
Switch Control Cable
The tally colour status change can be controlled
manually by inserting a switching cable (ground
loop) into the Tally Opto Sensor IN socket. An
operator in the control room, for example, could
then change the tally status when required.
Logic Control Connection
On the ClockPlus, a connection can be made to
the Tally Input socket to feed in a logic level
controlled tally signal. This could be sourced
from a tally control system already in use in the
studio.
For more information on the technical specifications required for the
tally connection methods, see
Alternative Tally Control Connections
on page 25.
Power Connections
TallyPlus Power Connections
Two lengths of cable are provided to connect DC power to the TallyPlus
from the monitor to cover either mounting position.
LED-TFT LED 8 ELP15
Power
cable - 0.3 m
Power
cable - 1 m
Monitor mounted
TallyPlus
TallyPlus
Hood mounted
TallyPlus