PIT INSTALLATION -- MODELS WITH BEVEL TOE GUARDS MOUNTED ON
SCISSOR LIFT or MOUNTED TO PIT FLOOR.
WARNING!
Do not install the turntable in a pit unless it has a bevel toe
guard or other approved toe protection. A shear point can exist
which can cause severe injury to the foot.
1. Check the pit dimensions. Length and width should be 2" longer (minimum) and 2”
wider (minimum) than the turntable or lift platform, whichever is greater.
2. Check the conduit chase entrance into the pit. The conduit diameter should be 3".
If the permanent electrical work is not complete, some means of temporary lines with
an on-off device for the motor control should be set up for testing purposes.
3. Make sure the pit floor is clean and level before starting. Lower the Lift and
Turntable into the pit and check for proper height. The turntable should be flush with
the pit angle framing. If needed, shim the LIFT BASE FRAME to the desired height.
DO NOT “spot” shim. Shim the ALL (4) Sides of the Lift base frame. This will
prevent the Lift Base from bending under an exceptionally heavy load.
16
CAUTION!
INSTALLATION INSTRUCTIONS
When lifting the turntable, do not attempt to pick it up by the
platform; it is attached only in the center and could be damaged.
Pick up the turntable from under the base frame ONLY using a
strap sling.
4. Make temporary electrical connections. Operate the turntable to ensure that rotation
is in the proper direction.