Autoplugin RCP-F2, User Manual

Page: 14 / 16

14
3 Battery low The module has
determined that battery
voltage at heater
startup or during heater
operation is lower than
specified in the settings
4.1 or 4.2 Charge car’s battery with
special charger (or start engine
to charge) or cancel 4.1/4.2
module’s settings
4 Time limits
exceeded Time limit for
autonomous operation
of the heater is
achieved (with active
setting 2.1) Run the engine or cancel 2.1
module’s setting
5 Unsuccessful
start The heater was
switched off
spontaneously at
startup Make diagnostics of the heater
if the error occurs again
6 Operation
cycle too
short The heater was
switched off
spontaneously with
operating time less
than 20 minutes Make diagnostics of the heater
if the error occurs again
8 CAN-bus
error There is a problem
with connection of the
module to the CAN-
bus Check the connection
9 Settings error Settings have been
incorrectly stored in
RCP memory
Reset the settings (8.1.1),
readjust RCP
11 Heater no
connection The heater is
unplugged from CAN-
bus or is out of order Make diagnostics of the heater