Oct/23/2006
MA200 IN REV.A
8
6. Press and hold the
+
buttons on the transmitter for 2 seconds. 2 long siren chirps will indicate
the unit is ready to accept adjustments of the “warn-away” sensitivity.
7. Press and hold
F
button on the transmitter for 2 seconds. [2] LED flash, [2] siren/horn chirps to
indicates the unit is ready to accept the adjustments of the shock sensor.
8. Pressing the
F
button on the transmitter once will decrease sensitivity level by one, each time an
decrease is made the siren/horn chirp will respond
number of chirp which indicates level of
sensitivity.
9. Pressing the
button on the transmitter once will increase sensitivity level by one, each time an
increase is made the siren/horn chirp will respond
number of chirp which indicates level of
sensitivity.
10. Hit the tank or strong metal part of the motorcycle to test the threshold level of the sensor.
a). Activate the warn-away (first stage the shock sensor), the siren/horn will emit a short chirp.
b). Activate the full alarm (second stage the shock sensor), the siren/horn will emit a long chirp.
11. When you are satisfied with the setting, press the
button one time to lock in the adjustment.
Note: If 20 seconds of inactivity expire, or the
button on the transmitter is pressed during of above
steps, the unit will exit the program mode and return to the disarmed mode. 3 long chirps will
confirm exit.
Power Save Mode for Motorcycle’s Power:
If the motorcycle has not been driven within
12 hrs
or the security system has not been activated by
remote control within
12 hrs,
the security system will automatically go into power save mode. While in
power save mode the security system will stay on at low current to save the motorcycle’s battery power.
When the system is in power save mode, all remote control function are bypassed, however the ignition
trigger / wire loop trigger / instant trigger / shock sensor (PS#2) trigger / starter interrupt feature will remain
operational.
EXIT THE POWER SAVE MODE:
Turn the ignition switch to ON then OFF to exit the power save mode.
Return To Factory Default Setting:
1. Turn the ignition ON then OFF 3 TIMES and stay in OFF position.
2. Push the Valet switch
12
times and hold in on the
12
th
push until
six
chirps and a long chirp is heard
then release the valet switch. You are now in the “Return To Factory Default Setting” programming
mode.
3. Press the
and
F
buttons at the same time on the transmitter together for 6 seconds, there will be a confirmation of six chirp
with 3 long chirp to confirm the system “Alarm Feature” all have returned to their factory default settings.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
960 Knox Street Unit B, Torrance, CA 90502
Tel: (310) 323-1800 or (800) 262-2527 www.autopageusa.com
