Oct/23/2006
MA200 IN REV.A
2
INSTALLATION
We recommend insulating all your soldered or crimped connections with heat shrink or electrical tape. We
also recommend spraying silicone sealant on all your connections and plugs after they are connected and
plugged in, spraying beforehand prevents good electrical connections.
Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass
through holes on the firewall to prevent fraying. Watch out sharp edges that may damage wires and cause
short circuit.
A. MOUNTING CONTROL MODULE:
Mount the control module with the tie-wraps or with the screws.
1. The control module and all of its components MUST be installed in a location where they cannot
become wet and be submerged in the water.
2. Keep it away from any heat sources or obvious leaks. Also keep the components and harnesses as far
from the exhaust as possible.
3. The higher the control module is mounted, the better the transmitter range will be.
B. MOUNTING THE SIREN: Optional
1. Place the siren in a location suitable for best sound results. Be careful not to mount the unit near
exhaust manifolds or other "hot" equipment and moisture area.
2. Mount it where a thief cannot easily disconnect it. Both the siren and its wires should be difficult to find.
This usually involves disguising the wire to look like a factory harness.
3. Preferred siren position is facing down so water does not collect in it.
4. When installing this system in watercraft, the siren must be mounted in a compartment that does not
take in water.
D. INSTALLING THE OVERRIDE/VALET/PROGRAM SWITCH:
The override/valet switch MUST be installed in a location where they cannot become wet and be
submerged in the water and in a hidden but accessible location. Drill a 1/4" hole at the location chosen and
use the nut and lock washer provided to secure the override/valet switch. Route this wire to the control
module.
C. INSTALLING THE LED STATUS INDICATOR:
1. The led indicator status should be visible from both side and rear of the motorcycle,
2. It need at least 1/2 inch clearance to the rear.
3. The LED fits in a 9/32 inch hole.
E. TRANSMITTER ANTENNA MODUL
Mount the transmitter antenna module with the tie-wraps or tape.
1. Keep the antenna module away from any heat sources or obvious leaks. Also keep the components and
harnesses as far from the exhaust as possible.
2. Mount the antenna module in a hidden but accessible location
3. Keep it away from large metal objects or chassis for best reception.
