August, 2005
RS2
7
H3/3. WHITE/VIOLET WIRE:– POSITIVE SAFETY SHUT DOWN INPUT
This wire provides an instant shutdown for the remote start, whenever it gets +12volts. If the brake lights switch in the
vehicle sw12 volts to the brake light circuit, connect this wire to the output side of the brake switch. This will
allow the remote start to shut down if an attempt is made to operate the vehicle without the key while running under the
control of the remote start. In most vehicles, in order to shift gear, the brake pedal must be depressed. The brake input
will in turn cause the remote start unit to shut off. See below diagram.
+12 volts from fuse box
To White/ Violet
wire
Brake light bulbs
Switch closes when
brake is depress
H3/4. WHITE/BLACK WIRE – NEGATIVE SAFETY SHUT DOWN INPUT --
The WHITE/BLACK wire provides an instant shutdown for the remote start, whenever it is grounded. Connect the wire
to the hood pin switch previously installed. This wire must be routed though a grommet in the firewall and connected to
the hood pin switch.
Important!
This connection is a safety wire and must be connected as shown and tested as specifiled. Failure to do
so may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be
used if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for ground
switched brake light circuits and must be connected to the output of the brake switch.
To:
White/Black
Wire /
Negative safety
To Vehicle Brake Switch
Hood Pin Switch
Diode
H3/5. GREEN WIRE – (-) INSTANT START & TURN OFF INPUT –
(See Feature
I - 1
Programming)
This wires activates and turns off the remote starter each time it sees a momentary ground signal. It is normally only
used for testing during installation or when activating the module from an after-market system.
H3/6. WHITE WIRE – (-) 200ma KEY SENSOR BY-PASS OUTPUT
This output is for a Key sense wire by-pass that some Chrysler and Toyota vehicles us to activate the remote start.
This wire comes on when the start is activated and stays on for 20 seconds.
H3/7. PINK WIRE – (-) 200ma PROGRAMMABLE OUTPUT
(See Alarm Feature
I - 2
Programming)
FACTORY SECURITY DISARM SIGNAL OUTPUT –(Factory Default Setting) --
This wire is designed to disarm a factory installed security system. This wire sends a negative (-) 1 seconds pulse
upon a remote start and remote door unlocking. Some factory systems must be disarmed to allow remote starting.
In most cases, this wire may be connected directly to the factory alarm disarm wire. The correct wire will show
nagative ground when the key is used to unlock the doors or trunk. This wire is usually found in the kick panel area
in the wiring harness coming into the car body from the door.
START STATUS (Shock Sensor Bypass Control) OUTPUT–
This wire is designed to by-pass shock sensor module. This wire will supply an output at all times the remote start
is operating plus an additional 3 seconds after the remote start unit turn off.
H3/8. YELLOW WIRE:- (-) 200ma IGNITION 3 OUTPUT–
This wire provides a 200mA (-) ground output that becomes active 4 seconds before the remote start unit initialize,
and remains grounded while running.
