C3 RS915 REV. O1
8
Under ignition ON, press and hold the
and
buttons at the same time for 2 seconds. The
parking lights will turn on for 1.5 seconds to indicate the system has entered the anti car-jacking
mode.
2. Once the system in anti car-jacking mode, the system will be triggered when any door is
opened and closed while the ignition is “ON”.
PASSIVE ANTI CAR- JACKING: (Programmable)
It will operate as noted below:
1. Turn the ignition switch to th
e “ON” position and the system will arm.
2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the door is
opened and closed while the ignition is “ON”.
TRIGGERING THE ANTI CAR -JACKING MODE:
A). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
B). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off the
car-jacking feature. If not, it will enter a second timer for carjacking.
C). 65 seconds after the system has been triggered, the siren will start sounding and the parking lights will start
flashing.
D). 90 seconds after the system has been triggered,
1. The siren will sound and the parking lights will flash, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and the
system disarmed
Note
: If you use password pin code to double protect the vehicle security, you will need to use it to completely
disarm the system.
N
. SYSTEM’S TRIGGER CHECK
(For two-way transceiver operation only)
Press and hold
F
button of LCD remote until 3 beeps sound , release and re-press
F
button again,
the LCD remote will show
“
ALARM
“
icon flash on text area (see advanced users mode), then
press
button to activate system trigger check.
Note: If the system has no response then you are out of range.
O
. SYSTEM’S STATUS CHECK
(For two-way transceiver operation only)
Press
F
button of LCD remote until 3 beeps sound , the LCD remote will show
“
STATUS
“
icon
flashing in the text area (see advanced users mode), then press
button to activate system status
check.
It responds
with one melody sound and all vehicles’
status records will immediately displayed on the
LCD screen.
Note: If it has no response then you are out of range.
P. DRIVER PAGING / LOST & FOUND
(
For two-way transceiver operation only)
This feature is useful the event that someone wants to page the driver of the parked vehicle or
someone cannot find his LCD remote transceiver.
Under the ignition switch “
OFF
” condition, press and hold the valet sw
itch for 2 seconds to page the
driver, one chirp sound shall be emitted from the vehicle and the paging melody sound continues
sounding from the Remote LCD transceiver.
Q. DOME LIGHT CONVENIENCE SUPERVISION (Optional Feature)
The alarm has a unique feature that will turn on your vehicle dome light as follows:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turning on the ignition switch or arming the alarm will turn off the dome light.
МSVMASTER
- Установка и разблокировка охранных систем автомобилей -
http://www.msvmaster.lv
МSVMASTER
- Установка и разблокировка охранных систем автомобилей -
http://www.msvmaster.lv
