Autonics LP-S044, User Manual

Page: 46 / 93

5 Start up LP
46 © Copyright Reserved Autonics Co., Ltd.
5.2 Operation order
Power ON
Power ON LP-S044 when LP mode switch is STOP.
Check LCD screen operation status of LP-S044 and power LED status.
※ 1
For your safety, delete downloaded program before.
※ 2
Create LP logic
program Create logic program from SmartStudio.
Download logic program to LP-S044.
※3
Create LP draw
program Create draw program from GP Editor.
Download draw data to LP-S044.
※3
Test drive
After placing LP mode switch is RUN, check logic program operation and
draw data operation.
Edit debugging and
program Edit logic and draw program errors.
You can utilize debugging function.
※4
Save program and
exit
Save logic and draw program to saved devices such as HDD etc.
After recording special information or printing program contents, exit the
operation.
※1. If there are error for LCD screen operation of LP-S044 and power LED, refer to ‘9
Troubleshooting ’
※2. To delete program, [SET ENVIRONMENT]-[CLEAR USER DATA] of system setting
menu or refer to ‘SmartStudio user manual’.
※3. Connection with SmartStudio, GP Editor and LP-S044 is able to connect(download,
upload, monitoring) by designated EDITOR port from [SET ENVIRONMENT]-[PLC
SETTING] of system setting menu. Therefore, you cannot connect SmartStudio and GP
Editor at the same time.
For example, during monitoring logic program of LP-S044 in SmartStudio, you cannot
downlaod draw data of GP Editor to LP-S044. For downloading draw data, you should
disconnect SmartStudio and connect GP Editor.
※4. SmartStudio supports several functions for debugging. For more details, refer to
‘SmartStudio user manual’s 7 Debug’.