2
Tech Support 770-844-4200
www.productivity2000.com
Input Specifications
Input Channels
8 inputs (1 common)
Input Ranges
0–5 VDC, 0–10 VDC
Signal Resolution
12–16 bit, depending on input resolution
0 - 5V Input Resolution &
Update Rate
(See Note 1)
Fine: 7.1 ms, 76μV, 16 bit
Medium: 1.78 ms, 305μV, 14 bit
Coarse: 444μs, 1.22 mV, 12 bit
0 - 10V Input Resolution &
Update Rate
(See Note 1)
Fine: 7.1 ms, 152μV, 16 bit
Medium: 1.78 ms, 610μV, 14 bit
Coarse: 444μs, 2.44 mV, 12 bit
Data Range
0–65535 counts
Maximum Continuous Overload ±100V, voltage input
Input Impedance
1MΩ (±10%) voltage input
Hardware Filter Characteristics Low pass 1st order, -3dB @ 80Hz
All Channel Update Rate
(See Note 2)
Fine 56.8 ms
Medium: 14.24 ms
Coarse: 3.55 ms
Conversion Method
Successive approximation
Accuracy vs. Temperature
±15ppm/°C maximum
Maximum Inaccuracy
0.1% of range
Linearity Error (end to end)
±0.015% of range maximum
Monotonic with no missing codes
Input Stability and Repeatability ±0.025% of range (after 10 minute warm-up)
Full Scale Calibration Error
(not including offset)
±0.05% of range maximum
Offset Calibration Error
±0.05% of range maximum
Maximum Crosstalk
-96dB, 1LSB
External DC Power Required
24VDC (-20% / +25%), 130mA
Output Specifications
Output Channels
4 (1 common)
Module Signal Output Range
0–10 VDC, 0–5 VDC
Output Signal Resolution
16-bit
Resolution Value of LSB
(least significant bit)
0–5 V = 76μV/count
0–10 V = 152μV/count
1 LSB = 1 count
Data Range
0–65535 counts
Output Type
Voltage sourcing/sinking at 10mA maximum
Output Value in Fault Mode
0V
Load Impedance
≥1.5 kΩ
Maximum Capacitive Load
0.01μF
Allowed Load Type
Grounded
Maximum Inaccuracy
0.1% of range
Maximum Full Scale Calibration
Error (not including offset error)
±0.065% of range maximum
Maximum Offset Calibration Error
±0.065% of range maximum
Accuracy vs. Temperature
±25ppm/°C max full scale calibration change
(±0.0025% of range/°C)
Max Crosstalk
-96dB, 1 LSB
Linearity Error (End to End)
±0.015% of full scale
Monotonic with no missing codes
Output Stability and Repeatability
±0.015% after 10 minute warm-up typical
Output Ripple
0.01% of full scale at 50/60 Hz
Output Setting Time
500μs max, 5μs min (full scale change)
All Channel Update Rate
5ms
Maximum Continuous Overload
Outputs current limited to 15mA typical
Type of Output Protection
15VDC peak output voltage
Output Signal (power-up, -down)
0V
Note 1: The Input Resolution of Fine returns 16 bit resolution. Medium and Coarse are 14
and 12 bit respectively. The 12 and 14 bit input values are scaled to 0–65535.
Note 2: Valid when all channels are set for the same Input Resolution.
