AutomationDirect OP-406, Manual

Page: 21 / 49

In
sta
lla
tio
n
an
d
S
pe
cif
ic
ati
on
s
2--9
Installation and Specifications
Selecting a Communications Cable
After configuration, connect the communications cable between the OP-panel and
the PLC. Use the following table to select the proper communications cable.
Cables for OP400 Series OptiMate Panel-to-PLC Connections
Family CPU (or other device) Port Cable Family CPU (or other device) Port Cable
Direct LOGIC
t
DL05 D0--05xx Ports 1 and 2 OP--2CBL--2
Direct LOGIC
t
DL105 F1--130 Only one OP--2CBL--2
Direct LOGIC
t
DL205 D2--230 Only one OP--2CBL--2
D2--240 Top port OP--2CBL--2
Bottom port OP--2CBL--2
D2--250 Top port OP--2CBL--2
Bottom port * (see note below)
D2--DCM (module) Only port * (see note below)
Direct LOGIC
t
DL305 D3--330 Requires DCU * (see note below)
D3--330P Requires DCU * (see note below)
D3--340 Top port OP--3CBL--1
Bottom port OP--3CBL--1
D3--350 Top port OP--2CBL--2
Bottom port * (see note below)
Direct LOGIC
t
DL405 D4--430 Top port (15-pin) OP--4CBL--3
Bottom port (25-pin) * (see note below)
D4--440 Top port OP--4CBL--3
Bottom port * (see note below)
D4--450 Phone Jack OP--2CBL--2
Top port (15-pin) OP--4CBL--3
Bottom port (25-pin) * (see note below)
D4--DCM (module) Only port * (see note below)
Slice I/O panels Only one OP--4CBL--3
TI305
t
/ SIMATIC â TI305
t
325--07, PPX:325--07 Requires DCU * (see note below)
330--37, PPX:330--37 Requires DCU * (see note below)
325S--07 (or 325 w/ Stage Kt) Requires DCU * (see note below)
330S--37, PPX:330S--37 Requires DCU * (see note below)
335--37, PPX:335--37 Phone Jacks OP--3CBL--1
If DCU is used * (see note below)
TI405
t
/ SIMATIC â TI405
t
425--CPU, PPX:425--CPU Only one OP--4CBL--3
PPX:430--CPU Top port (15-pin) OP--4CBL--3
Bottom port (25-pin) * (see note below)
435--CPU, PPX:435--CPU Top port (15-pin) OP--4CBL--3
Bottom port (25-pin) * (see note below)
Smart Slice
t
I/O panels Only one OP--4CBL--3
Allen-Bradley
t
SLC 500 5/03, 5/04 Bottom port OP--ACBL--3
Allen-Bradley MicroLogix Only one OP--ACBL--4
* Note: Pre-assembled cables for connecting to these ports are not supplied by Automationdirect.com ;
however, you can use the cable pinout diagrams in the following section to make your own cables.