Automation Technology C4-1280-GigE, Hardware Reference Manual

Page: 15 / 35

C4-1280-GigE Camera Hardware Reference Manual Rev. 1.4
•
11
EnableDC1Width AT IBoolean R/W Controls the output in channel DC1, when COG
algorithm is selected: True: DC1 outputs the laser
line width. False: DC1 outputs the left edge
position.
EnableDC1Flags AT IBoolean R/W When in 16 bit mode, the bits 12-15 of output
channel DC1 contain additional algorithm flags
EnableDC2TrshSP AT IBoolean R/W Controls the output in channel DC2, when TRSH
algorithm is selected: True: DC2 outputs the line
position value with one subpixel. False: DC2
outputs the right edge position.
Camera Controls – Commands
Name Rev. Interface Access Description
CalibSensor AT ICommand W Start internal sensor FPN calibration.
StartPulse AT ICommand W Send Start pulse.
StopPulse AT ICommand W Send Stop pulse.
TriggerPulse AT ICommand W Send Trigger pulse.
Camera I/O
Name Rev. Interface Access Description
Input1 AT IEnumeration R Lists the input signals available for IN1:
- Input1_Unused.
- Input1_FrameStart
- Input1_EnableFrame
- Input1_Trigger
Input2 AT IEnumeration R Lists the input signals available for IN2:
- Input2_Unused.
- Input2_StopFrame
- Input2_Trigger
Output1 AT IEnumeration RW Selects the output signal for OUT1:
- Out1_IntegrationActive
- Out1_SequencerActive
- Out1_IntegrationDualSlopeActive
- Out1_IntegrationTripleSlopeActive
- Out1_High
- Out1_Low
- Out1_InternalTrigger
Output2 AT IEnumeration RW Selects the output signal for OUT2:
- Out2_IntegrationActive,
- Out2_High
- Out2_Low
- Out2_IntegrationDualSlopeActive
- Out2_IntegrationTripleSlopeActive
- Out2_TriggerOverrun
- Out2_ResolverCountDir
- Out2_TriggerBusy
TriggerOverrun AT IBoolean R Trigger Overrun Flag.
Input1Level AT IEnumeration R The voltage level of IN1:
- Input1Level_High
- Input1Level_Low
Input2Level AT IEnumeration R The voltage level of IN2:
- Input2Level_High
- Input2Level_Low
RS422ChannelALevel AT IEnumeration R Voltage level of RS422 Channel A:
- RS422ChannelALevel_High
- RS422ChannelALevel_Low
RS422ChannelBLevel AT IEnumeration R Volatge level of RS422 Channel B
- RS422ChannelBLevel_High
- RS422ChannelBLevel_Low
LaserPower AT IInteger R/W Sets the output analog voltage of illumination control
in the range 0.0-5.0 V DC (corresponds to 0...100%)
LaserTurnOn AT IInteger R/W Laser turn on/off.
VoltageIn AT IFloat R Reads the input analog voltage of illumination control
(range 0.0-5.0 V DC)