Page 10
igus XYZ Gantry User Manual – 1st Ed – 09/14/2022
igus
XYZ g
antrY
u
ser
M
anual
SAW Series Assembly/Disassembly
The following assembly steps can be followed in the reverse order for disassembly.
NOTE: Steps shown below are the same for both ends of the Actuator.
1. Loosen 4 screws on Carriage Plate.
2. Install Carriage Plate subassembly by aligning the Bearing Liners with the top rails and Lead Nut with the Lead
Screw. Lead Nut should be opposite side from the input shaft. Turn Lead Screw to engage with Lead Nut. This
will pull the Carriage Plate fully onto rails.
3. Gently install O-ring onto Lead Screw until seated into notch (SAW1040 only).
4. Install end block.