Automation Direct FLI-150, Quick Setup Manual

Page: 139 / 145

7
Section
Cleaning
CAUTION: SHUT OFF YOUR TOUCH SCREEN BEFORE CLEANING!!
IF YOUR DISPLAY IS A –TS MODEL, THAT IS A TOUCH SCREEN DISPLAY,
THE SCREEN WILL BE ACTUATED BY CLEANING. PRESSING ON THE
SCREEN WHILE CLEANING WILL BE SEEN AS A TOUCH TO THE SYSTEM
WHICH COULD CREATE A POTENTIALLY DANGEROUS CONDITION!!
Occasionally clean the display panel and cabinet with a soft cloth dampened (not
soaked) with a mild (non-abrasive) glass cleaner. Keep turning a fresh side of the
cloth toward the screen surface to avoid scratching it with accumulated grit.
Note:
The solvent should be applied only to the cloth, and not directly on the
monitor screen.
Do not use paper products as they may scratch the surface. To minimize the risk
of abrasion, allow the screen to air dry. Special care should be taken when
cleaning a touch screen or polycarbonate shield that is installed over the screen.
Abrasive and certain chemical cleaners can damage the surface.
Never use alcoholic or ammoniac cleaners to clean the polycarbonate shield or a
touch screen.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be replaced if
the insulation becomes broken or if it develops a loose internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for
the power cord replacement described above.
Cleaning &
Maintenance