Owner Installation Instructions
GDO-11v1 Ero®
5
The unit should be installed so that it is protected from the elements. It should not be exposed to water or rain.
It is not to be immersed in water or sprayed directly by a hose or other device.
The garage door must be
well balanced.
Sticking or binding doors must be repaired by a qualifi ed garage
door installer prior to installation of the opener.
Frequently examine the installation, in particular cables, springs and mountings for signs of wear, damage
or imbalance.
DO NOT
use if repair or adjustment is needed since a fault in the installation or an
incorrectly balanced door may cause injury.
DO NOT
attempt to repair the door yourself as hardware
is under extreme tension.
Remove or disengage
all garage door locks and mechanisms prior to installation of the opener.
Connect the opener to a properly
earthed
general purpose 240V mains power outlet installed
by a qualifi ed electrical contractor.
Disconnect the power cord
from mains power before making any repairs or removing
covers. Only
experienced
service personnel should remove covers from the opener.
In order for the Ero™ to
sense
an object obstructing the door way, some
force
must
be exerted on the object. As a result the object, door and/or person may suffer
damage
or
injury.
If the power supply cord is damaged, it
must
be replaced by an Automatic
Technology service agent or suitably qualifi ed person.
Make sure that the door is fully open before driving in or out of the garage
and fully closed before leaving the driveway.
Make sure that remote controls are kept out of reach of children.
Install the (optional) wall switch or (optional) wall mounted
transmitter in a location where the garage door is visible, but
out of the reach of children at a height of at least 1.8 metres
from the fl oor.
Important Safety Instructions
